|
|
Post by twoodard on Feb 11, 2011 18:37:10 GMT -5
SO I got this take off factory barrel for my project. took my sabot bullet combo I use in my first gun and it loads way to easy. it is a HPH 12 sabot with .452 flex tip. any suggestions on a tighter fitting load?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Feb 11, 2011 18:50:28 GMT -5
Try using the Harvester Red Crushed Rib sabot....I believe that it will give you a tight enough fit. Many of the factory Savage barrels are loose as they say, mine was. When shooting a .451-.452 bullet the Harvester Red worked well.
Zen
|
|
|
|
Post by twoodard on Feb 11, 2011 18:54:34 GMT -5
ill get some. thanks been a while since ive had to work up a new load
|
|
|
|
Post by mountainam on Feb 11, 2011 18:59:32 GMT -5
You could try a Harvester black crush rib sabot with a .458" Rem 300gr HP. They usually have a snug fit.
|
|
|
|
Post by twoodard on Feb 11, 2011 19:30:59 GMT -5
would like to say away from that heavy of a bullet. but will look into it thanks
|
|
|
|
Post by skennedy on Feb 11, 2011 19:51:55 GMT -5
I have two ML ll and when using harvester easy load sabots and a .451 bullet one is real easy to load and the other one is fairly hard to load. On the easy one I can push the sabot/bullet into the barrel with my thumb and the other one is hard to get started even using a starter.
|
|
|
|
Post by Richard on Feb 11, 2011 21:38:21 GMT -5
OR, you could knurl the bullet a little for a tighter fit?
Richard
|
|
|
|
Post by twoodard on Feb 12, 2011 10:25:08 GMT -5
that is also a possibility. what are most getting .002" ?
|
|
