Ring height for accura

[rangeball]

Buddy will be mounting a bushnell trophy XLT with BCD reticle on the accura. I'm recommending burris signature Z rings, scope is 3x9x40 with a 1" tube and 4" of high relief. What's the shortest rings we can use and still get adequate access to the hammer?

[Deleted]

i use the Dura sight QD rings on my 3-9x40 and they are medium height

[rangeball]

Any idea if their DEAD-ON one piece base rings system will fit the last years accura?

www.durasight.com/durasight/z2-alloy-products/integral-mount-systems/dead-on-one-piece-rail-system.html

It says accura V2, but aren't the barrels and mount hole spacing the same for the accura V1 and V2?

[Deleted]

no the hole spacing is much different. Its for the 2010 model CVA's

[rangeball]

Aug 30, 2010 11:34:30 GMT -5 frontiergander said:

no the hole spacing is much different. Its for the 2010 model CVA's

You're kidding? I called and the guy said it would fit?

It's been ordered, so if you're sure please let me know so it can canceled.

[rangeball]

I called again, they said it will fit, but only one direction. We'll see.

[Deleted]

i think you'll only be able to use 3 holes rather than the 4.

I hope they are right though and it fits. Its a really good sturdy set up

[rangeball]

I was thinking it only showed 3 holes, but looked again and see the hole in the ring. This should be lock-tited down when installed, right?

[Deleted]

Yeah use the blue loc-lite. A little goes a long ways. If you can use all 4 holes, start in the middle and work your way out.

[rangeball]

Thanks for all your help

[wyohunter]

Aug 26, 2010 12:23:39 GMT -5 frontiergander said:

i use the Dura sight QD rings on my 3-9x40 and they are medium height

I have the same on my Accura with my Nikon Omega 3x-9x.