Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 12, 2010 15:58:40 GMT -5
A question for Richard, edge,sw or any of you gents with more duplex experience than myself. I have searched for n 130 or n133 for a while now and came up with a can of n133. what would be a good place to start with the n110/n133 duplex in a 28" pacnor 45? my goal is to get upwards of 3k with good accuracy.........thanks..Bill
|
|
|
Post by edge on Jan 12, 2010 16:10:29 GMT -5
A question for Richard, edge,sw or any of you gents with more duplex experience than myself. I have searched for n 130 or n133 for a while now and came up with a can of n133. what would be a good place to start with the n110/n133 duplex in a 28" pacnor 45? my goal is to get upwards of 3k with good accuracy.........thanks..Bill At the top of this page hit search. Do a search on this website for: N133 Search posts made by: Richard Set the days to: 365 Maximum results: 100 and you should get plenty of hits. edge.
|
|
|
Post by Richard on Jan 12, 2010 17:16:13 GMT -5
Edge........Thanks for providing that information for Hillbill! Bill: Actually, if you take any of the loads in which I use N-130, just substitute N-133 by a couple of grains. A typical duplex for me using N-110 and N-133 will run about 100 fps slower than if I had used an equal amount of N-130, My problem is my barrel is just too short to get the velocity I want with N-133. Richard
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 12, 2010 17:33:48 GMT -5
thanks guys, will post range results soon.....Bill
|
|