|
|
Post by jims on Jul 18, 2009 22:33:00 GMT -5
My chrony f-1 is reading err. A new battery did not correct it. I do not have the instructions readily available, source of problem and cure? Thanks
|
|
|
|
Post by mshm99 on Jul 18, 2009 23:25:20 GMT -5
|
|
|
|
Post by deadeye on Jul 19, 2009 8:28:36 GMT -5
try shooting in overcast conditions not in direct sunlight without the diffusers,also a tip to pass along,on your metal rods,put some white electrical tape approx 1'' from top on each rod,(this is where i align my crosshair to)on guns use the narrower hole options,archery the wider hole selections,this will help in a square alignment to get the projectile over both sensors,i use 10ft but sometimes go to 25ft& 78ft for my 1,000yd work,hope this helps!
|
|
|
|
Post by jims on Jul 19, 2009 22:20:48 GMT -5
Thanks all. I will try those ideas.
|
|
|
|
Post by jims on Jul 20, 2009 20:36:35 GMT -5
The unit reads err 1 on turning it on, even in the house. I looked at the instructions and will proceed from there but any others that have experienced that and cures?
|
|
|
|
Post by minst7877 on Jul 20, 2009 20:54:47 GMT -5
On mine that means there is a problem with the front sensor. You might want to try cleaning the sensor lens with a good optics cloth and lens cleaner.
DC
|
|
|
|
Post by jims on Jul 21, 2009 6:20:24 GMT -5
It was sitting in the barn for awhile so it could have dirt/dust on it.
|
|
|
|
Post by jims on Jul 22, 2009 16:08:26 GMT -5
I cleaned it, it now reads AL and flashes on each side of that and at times will back to err 1.
|
|
|
|
Post by minst7877 on Jul 22, 2009 21:51:56 GMT -5
Put in a new battery.
|
|
