dan09
Button Buck
Posts: 2
|
Post by dan09 on Apr 20, 2016 4:25:57 GMT -5
Is 65 grains of reloader 7 safe with a 325 grain Hornady ftx shot from a 50 cal stock Savage m/11. Can you read any pressure signs from a shot primer. Thanks for any replies.
|
|
|
Post by rossman40 on Apr 20, 2016 11:11:09 GMT -5
I think you'll be OK at 65grs with a 327gr bullet. Someone was shooting like 70gr behind a 300gr IIRC. TG only traced 250gr bullet loads and with 70gr those only traced around 30ksi. I shot some RL10 a few months ago and it showed some promise in a stock .50.
With the vent you may not see pressure signs on the primer till it's too late.
|
|
|
reloader 7
Apr 20, 2016 13:08:42 GMT -5
via mobile
Post by rlp10ml on Apr 20, 2016 13:08:42 GMT -5
When I had my Savage,my go to load was 67 grains RL7 with the 300 grain Barnes Original....
|
|
|
Post by TGinPA on Apr 20, 2016 15:35:47 GMT -5
5K) PN45 RL7 70gr 327gr mh fiber wad knurled 4/20/16 (25in bbl) The load traced above seemed safe in conditions present at the time but may not be under other conditions. TG
|
|
|
Post by 10ga on Apr 20, 2016 15:50:54 GMT -5
d**n, my shoulder hurts just looking at that load/curve! 10
|
|
|
Post by Dave W on Apr 20, 2016 17:20:34 GMT -5
I think it will be OK, I used to shoot 67gr with the .457 300 Rem with a Har BCR sabot.
|
|
|
Post by rambler on Apr 20, 2016 17:36:30 GMT -5
That's looking pretty stout. Thanks TGinPA for putting that info out there.
|
|
|
Post by rossman40 on Apr 20, 2016 20:20:03 GMT -5
You have to remember he is shooting in a .50 so the curve is going to be a tad different then the trace showed which was a .45.
|
|
|
Post by ourway77 on Apr 21, 2016 5:56:50 GMT -5
When I had my Savage ML'er II I shot Re-7 65.0 grains with 250 and 300 bullets also shot 68 grains but accuracy fell off
|
|
|
Post by rossman40 on Apr 21, 2016 16:57:58 GMT -5
Going to be a thumper for sure, looking at 4770fpe if it comes out at the traces speed. Might not be very sabot friendly.
|
|
dan09
Button Buck
Posts: 2
|
Post by dan09 on Apr 21, 2016 18:45:18 GMT -5
Thanks for reply. I am only getting about 2150 fps . Should it be faster than that.
|
|