|
Post by lbahunter on Sept 26, 2019 16:51:06 GMT -5
I have been researching, sending texts, making phone calls to builders about doing one. Once I get a couple of projects out of the way, I gonna get the ball rolling on one.
|
|
|
Post by dperry on Oct 4, 2019 7:53:53 GMT -5
I have an 35 whelen Apex that is converted. First one ever done I think but there has been quite a few since. It shoots good.
|
|
|
Post by lbahunter on Jan 24, 2020 16:23:12 GMT -5
Update Have one on the way!!!!
|
|
|
Post by ET on Jan 25, 2020 1:00:38 GMT -5
Update Have one on the way!!!! Look forward to hearing of your experience when the new arrival makes its debut. I don't respond a lot with calibers I'm not familiar with but I still enjoy the read. Ed
|
|
|
Post by kennacl55 on Jan 25, 2020 11:32:50 GMT -5
I would like to hear more about these 35 caliber builds also. What loads, powders, bullet weights, and velocity, etc.
|
|
|
Post by lbahunter on Jan 25, 2020 18:10:59 GMT -5
Looking forward to experimenting with it!!!!
|
|
|
Post by lbahunter on Feb 4, 2020 17:38:27 GMT -5
I'm thinking about getting some Fury .358 bullets to try.
|
|
|
Post by lbahunter on Feb 7, 2020 17:47:13 GMT -5
I full form sized a Hornady 180 gr XTP yesterday. I had made no adjustment to the die from the previous owner. Once the rifling aligned it fell in a little ways, could still see the bullet. I took the ramrod and pushed it through with a very firm one hand. The full form die may need a little tweaking for a fouled barrel. I tried to full form a Barnes 140 XPB. I should have run it through the smooth form die first to make it easier. Lesson learned!!!!
|
|
|
Post by carsyn22 on Jan 25, 2021 18:35:25 GMT -5
I'm tagging in! I don't have experience with this but I am interested in sub cals.
|
|
|
Post by dannoboone on Jan 26, 2021 18:47:00 GMT -5
.I tried to full form a Barnes 140 XPB. I should have run it through the smooth form die first to make it easier. Lesson learned!!!! Annealing the XPB's softens them up very nicely. I have annealed those for the S&W .460 and full formed them for my .451 barrel. Once annealed, they go right through.
|
|
|
Post by lbahunter on Jan 29, 2021 17:37:30 GMT -5
.I tried to full form a Barnes 140 XPB. I should have run it through the smooth form die first to make it easier. Lesson learned!!!! Annealing the XPB's softens them up very nicely. I have annealed those for the S&W .460 and full formed them for my .451 barrel. Once annealed, they go right through. I was experimenting without sizing them down before full forming. I now have a small arbor press I do my sizing on. It works much better for me either smooth or full form
|
|