|
Post by tnhunter on Oct 19, 2017 20:06:01 GMT -5
I bought a 700ml of a member on here a while back and it already had the bolt nose kit and breech plug installed. Where can I buy the vent liner that screws in the end of the plug? This plug looks like the savage that fits the Remington threads I guess. Also how can you disassemble the bolt with the bolt nose kit installed?
|
|
|
Post by lwh723 on Oct 19, 2017 20:50:15 GMT -5
I bought a 700ml of a member on here a while back and it already had the bolt nose kit and breech plug installed. Where can I buy the vent liner that screws in the end of the plug? This plug looks like the savage that fits the Remington threads I guess. Also how can you disassemble the bolt with the bolt nose kit installed? ASG026. Available at link below. www.arrowheadsporting.com/breechplugs.htmlCleaning options are a little limited. Bolt nose isn't easily pulled, so you pretty much have to clean from back after you pull firing pin assembly.
|
|
|
Post by tnhunter on Oct 19, 2017 21:04:53 GMT -5
Thanks Luke. Will the Lehigh fit in it to? I guess I should have been a little more specific. How do I pull the firing pin? I’ve done it on the stock ml bolts but I don’t see how to do it on the one with a bolt nose attached. Do I need to put a little anti seize on the vent liner. I’m using a light load of BH209 In this gun for my son should I use some type of Teflon tape on the breech plug like I do with my smokeless gun?
|
|
|
Post by AJ on Oct 20, 2017 7:35:01 GMT -5
Either ventliner should work for you. With the new plug and bolt nose kit you do not need to clean the firing pin spring like you did with the original 700ML. Anti seize on the threads will definitely help down the road getting the parts apart.
|
|