|
Post by 19hunt92 on Feb 20, 2017 21:06:00 GMT -5
Can someone recommend a gun smith that can thread an ithaca Mag 10 for browning invector chokes? the end of the barrel OD is .892 but i would be more than willing to take a couple inches off to get to .9 OD or larger if needed.
Looking to make this an even better goose gun and possibly turkey gun if its a short walk.
Thanks for the info ahead of time.
|
|
|
Post by jaycee on Feb 22, 2017 11:11:18 GMT -5
I sent my Ithaca Mag.10 , To Briley in Texas, they installed Briley Thin Wall Tubes , that are steel shot compatable, the gun now is very versatile can be used with steel shot for waterfowl, or lead shot for anything else. I am very satisfied with it.
|
|
|
Post by 10ga on Feb 24, 2017 22:12:55 GMT -5
jaycee above X2....
I sent my Ithaca Mag.10 , To Briley in Texas, they installed Briley Thin Wall Tubes , that are steel shot compatable, the gun now is very versatile can be used with steel shot for waterfowl, or lead shot for anything else. I am very satisfied with it.
I can tell you that getting those thin Mag 10 barrels retro fitted for chokes isn't easy. The barrel is too thin for fitting for Browning chokes. I had my mag 10 also sent to Briley for fitting with threaded choke tubes. I too am very satisfied. 10ga
|
|
|
Post by xp100 on Jun 30, 2019 9:58:27 GMT -5
I sent a couple out to Carlson when I had my shop. reasonable price, great work and quick turn around. choketube.com
|
|
tedb
8 Pointer
Posts: 108
|
Post by tedb on Jun 30, 2019 15:07:54 GMT -5
Either one will do the job.
|
|