|
Post by brucep on Sept 8, 2017 21:26:35 GMT -5
Hello All
New to the forum or otherwise known as the FNG. I have a question regarding the trigger on my ( new to me 700MLS ) I sent the bolt off to have the 209 hunter conversion kit since I didn't have a mill end bit or reamer to do the firing pin and didn't want it to walk on me while drilling something round. Today I finished doing a GunKote job since it had a few scratches on the barrel. Well, while putting it back together my brother went to hand me the trigger assembly and dropped it and of course it landed right on the safety switch and the d**n thing broke off.
I know, long winded way of asking if a 700 trigger assembly will work on it. I was looking at the X-Mark Pro but I wanted to make sure it will fit correctly AND if it does what is the best way to remove the bolt release lever.
Thank you in advance and my apologies if I posted this in the wrong section
|
|
|
Post by lwh723 on Sept 8, 2017 22:15:22 GMT -5
Yes any 700 trigger will work. Good excuse to upgrade to triggertech or timney.
|
|
|
Post by brucep on Sept 9, 2017 8:53:13 GMT -5
Thank you Sir !
|
|