Front Sight Height for 10 ML-II with Williams WGRS Peep

billyboy
10 Pointer

Posts: 295

Front Sight Height for 10 ML-II with Williams WGRS Peep May 4, 2015 14:00:06 GMT -5

Quote

I installed a Williams WGRS - SAVAGE Peep Sight on my stock 10ML-II & the Factory installed Fiber Optic front sight is too low.

ITEM

70220 .485 Height One Piece Fiber Optic Front is too Low

70678 .634 Height One Piece Fiber Optic Front is too High

Williams Tech Steve sent me a One Piece off of a Remington 597 Set so I didn't have to deal with a Ramp and Dovetail!

ITEM

70490 .535" Height One Piece Fiber Optic Front works and is available direct from Steve and the Part Number is not in their Online Catalog.

I hope this is helpful for anyone planning a Colorado Muzzleloader Hunt.

rossman40 Global Moderator Posts: 3,920	Front Sight Height for 10 ML-II with Williams WGRS Peep May 5, 2015 13:19:02 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by rossman40 on May 5, 2015 13:19:02 GMT -5 This is on a Accutrigger (round rear ring) right?
	The tricky stuff is best left to those who are highly experienced in operating at the ragged edge of stability and sanity.

billyboy 10 Pointer Posts: 295	Front Sight Height for 10 ML-II with Williams WGRS Peep May 5, 2015 15:49:37 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by billyboy on May 5, 2015 15:49:37 GMT -5 Yes, Round Receiver with Accutrigger. I believe it is a 2007.