|
Post by jims on Nov 23, 2014 20:49:13 GMT -5
It is a 56mm bell so it should be about 1/8 inch on the bottom closer than a 50mm. Do you have at least 1/8 inch clearance?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 23, 2014 21:14:29 GMT -5
Mine is less then an 1/8th. Ohioguy put the WCE 56mm on a 700ML and used the DNZ high.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 23, 2014 21:46:47 GMT -5
Mine is less then an 1/8th. Ohioguy put the WCE 56mm on a 700ML and used the DNZ high. It didn't leave a bunch of room there for sure, fit about perfect as far as looks go, his shank was 1.200" out to 3 1/4" ahead of the action for reference.
|
|
|
Post by jims on Nov 23, 2014 22:06:36 GMT -5
This is on a stock .50 Savage. The barrel is thinner. Currently it has on a Weaver style base and rings and has about 1/8 clearance. I have found that the DNZs seem to run a bit high. I got by with lows on a large bell that was on a Rem 700 with a pencil barrel. Different creatures of course. From what info I gained it looked like it would be quite close but no actual real world experience.
|
|
|
Post by jims on Nov 24, 2014 20:21:08 GMT -5
Dednutz is always great about getting back timely with answers. Tim Work does not think the medium will work and perhaps not even the high. He said I would need the barrel to be at least .140 lower than the top of the receiver for it to work with the high. I cannot get an easy measurement until after season when I remove the current setup. It looks from eye estimation that the difference is about .125. If any of you have a large shank round top Savage MLII without a scope on it if you can give me the difference in height from the top of the receiver (the step down or drop off) at the barrel about 3 to 4 inches more towards the muzzle I would have the information needed. If I cannot get the DNZ to fit I will just use my Farrell base and appropriate rings. Thanks
|
|
|
Post by jims on Nov 25, 2014 7:35:45 GMT -5
I took some measurements as best I could, looks close but too close it appears.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 25, 2014 20:41:28 GMT -5
My barrel profile is probably heavier than yours, and we are comparing rem to Sav, but my WCE barely clears with the DNZ high mount.. It wouldn't even be close to fitting on my gun with a medium.
|
|